-
Installment Payment for Online Monitoring of Power Fiber Optic Cables
By listening to acoustic indicators of functional performance, this system provides on-line, cost-effective power cable condition monitoring at each point along the entire asset.
-
Relay Protection Virtual Platform Design
This whitepaper, co-authored by Intel and Kalkitech describes the virtual protection relay (VPR) concept – an architecture where software-defined and virtualized platforms are deployed to host the critical circuit protection functions for an advanced and agile grid. We assert that this use of. Edge Analytics the availability of IEC-61850-3 certified servers built for substations and VMware vSphere supporting latency-sensitive workloads in the substation. Modern substations require standardized, flexible, scalable, and secure systems to build a data-driven power grid to improve the local. A Virtual Protection Relay is a protection system implemented entirely in software instead of a physical relay box. We outline virtualizati n technology and the networking aspects using performance benchmarks laid by IEC 61850 standards. Protective relays have evolved steadily over time. Early power systems relied on electromechanical relays, which were later. As the energy sector is confronted with the high penetration of renewable energy sources, one of the key aspects of the grid controls which are put under stress is the grid protection sub-system.
[PDF Version]
-
Which end of the optical attenuator goes in
They are usually installed at the transmit end of active modules, such as OTU and OSC boards, to prevent the downstream receiver modules from being burnt due to excessively high output optical power. The disadvantage is that the attenuation value cannot be adjusted. An optical attenuator, or fiber optic attenuator, is a device used to reduce the power level of an optical signal, either in free space or in an optical fiber. Why Do We Need the Optical Attenuator? The receiver of an optical module has. Transmitter power (TP) = 3dBm Receiver maximum optical input power (MP) = -6dBm Total losses (TL) = 5dB Minimum attenuation required = MP + TL – TP = -6dBm + 5dB – 3dBm = – 4 dB At a minimum, a 4 dB attenuator is required. Fiber-optic systems use a wide variety of relays, switches, amplifiers, and other devices that are connected by fiber-optic cables. Attenuators are extensively used across.
[PDF Version]